Yeast Pitch Rate Calculator

Enter batch volume, gravity and pitch rate to size your yeast pitch.

How it is calculated

Enter batch volume in liters, original gravity in degrees Plato (°P, not specific gravity such as 1.048) and the target pitch rate in million cells per milliliter per °P. The tool converts liters to milliliters and computes cells (billion) = rate × volume(mL) × °P ÷ 1000. It then divides by the viable cells per pack that you enter to show packs. The default, 100 billion, is a round figure for a fresh liquid pack, not any maker's specification: White Labs, for example, says one PurePitch Next Generation homebrew pouch in 20 L gives 7.5 million cells per mL, which is about 150 billion cells. Use the count your yeast maker states, and lower it for an older pack. It also prints the same total written out as a full number of cells. All three inputs must be above zero. The count is for viable cells, so old or poorly stored yeast needs a larger pitch.

Worked example

A 20 L batch at 12 °P with a pitch rate of 0.75 million cells per mL per °P. Volume in milliliters: 20 × 1000 = 20,000. Cells: 0.75 × 20,000 × 12 ÷ 1000 = 180 billion cells. Packs at 100 billion cells each: 180 ÷ 100 = 1.80 packs. In full that is 180,000,000,000 cells. At a pitch rate of 1.5 the same batch would need 360 billion cells, or 3.60 packs.

Try this example →

Common mistakes

  • Entering specific gravity (1.048) instead of degrees Plato (about 12). The result would be roughly twelve times too small, so convert first.
  • Typing the volume in US gallons. The field is liters; 5 gallons is about 19 L.
  • Using the rate for the wrong beer style. Lagers and high-gravity beers are normally pitched at a higher rate than ordinary ales, so the same batch may need twice the cells.
  • Leaving the cells per pack at 100 billion. That is only a round default; enter your maker's figure, and remember packs lose viability with age and heat, so round up or make a starter.
  • Mixing up millions and billions. The rate is in million cells per mL per °P, while the total is shown in billions of cells.

Sources

About this calculator

Pitch rate in brewing is the concentration of viable yeast cells added to a batch of wort, and it's one of the biggest levers a brewer has over fermentation character — underpitching stresses the yeast into producing excess esters and fusel alcohols (off-flavors), while overpitching can strip flavor complexity and cause premature flocculation. Pitch rate is conventionally expressed in million cells per milliliter per degree Plato, scaling the target cell count to both the batch's volume and its sugar density (gravity).

This calculator converts your batch volume, original gravity, and target pitch rate into the total number of yeast cells needed and the corresponding number of commercial yeast packs to pitch. It's a practical tool for homebrewers using liquid or dry yeast, especially useful for higher-gravity beers (like imperial stouts or barleywines) that require significantly more yeast than a standard-strength ale to ferment cleanly.

Was this helpful?

You can pick up to 3 reactions.

Note from the editors

Packs cannot be split, so rounding up is the usual choice. In the default 20 L batch the tool says 1.80 packs; two whole packs give about 0.83 million cells per mL per degree Plato instead of 0.75, a slightly heavier pitch than planned. Enter your maker's cells per pack (100 billion is only a round default) and check the packaging date, as the count assumes full viability. Which beer style and pitch rate do you use, and do you build a starter first?

Comments

  • Be the first to comment.

Popular calculators

All Calculators