Torricelli's Law Calculator

Find how fast fluid jets from a hole below the surface.

How it is calculated

The speed of a liquid leaving a small hole is v = √(2 × g × h), where h is the depth of the hole below the free surface in meters and g is gravitational acceleration in m/s². If you leave g empty, zero or negative, the tool uses 9.81 m/s². The speed is given in m/s and also in km/h (multiplied by 3.6), rounded to two decimals. The depth must be above zero. This is the ideal speed: it assumes a wide tank, a small hole and no friction. A real jet is somewhat slower, and the tool does not compute flow rate, which also needs the hole area and a discharge coefficient.

Worked example

A tank has a small hole 1.5 m below the water surface, with the default g of 9.81 m/s². Inside the root: 2 × 9.81 × 1.5 = 29.43. Square root: √29.43 ≈ 5.425, shown as 5.42 m/s. In km/h: 5.425 × 3.6 ≈ 19.53 km/h. This is the same speed a stone reaches after falling freely 1.5 m. On the Moon (g = 1.62), the same depth would give about 2.20 m/s.

Try this example →

Common mistakes

  • Using the total height of the tank instead of the depth of the hole below the water surface. Only the vertical distance from the surface down to the hole counts.
  • Entering depth in centimeters or inches. The result assumes meters together with g in m/s², so 150 cm typed as 150 gives a speed exactly ten times too high (√(150 ÷ 1.5) = 10).
  • Expecting the speed to depend on the liquid. Density cancels out, so water, oil and syrup leave at the same ideal speed (viscosity only matters in real conditions).
  • Treating the result as flow rate. Volume per second also needs the hole area and an allowance for the contraction of the jet.
  • Assuming the speed stays constant. As the tank drains, h falls and so does the speed, so the number is valid only for the depth you entered.

Sources

About this calculator

This calculator finds the efflux velocity of liquid escaping through a hole using Torricelli's law: v = √(2gh), where g is gravitational acceleration and h is the depth of the hole below the fluid's surface. Evangelista Torricelli published the result in 1644, in De motu gravium (part of his Opera geometrica): the exit speed equals the speed a body reaches falling freely from height h. Nearly a century later Daniel Bernoulli's Hydrodynamica (1738) analyzed water flowing from a hole, and the law is now taught as a special case of Bernoulli's equation.

Engineers use it to estimate drain and tank discharge rates, size orifices for irrigation and industrial fluid systems, and it's a classic demonstration in fluid mechanics courses of energy conservation in a flowing liquid.

Was this helpful?

You can pick up to 3 reactions.

Note from the editors

Speed depends on the depth below the surface, not on what the liquid is: water and oil would leave the hole at the same ideal speed. As the tank drains, depth falls and so does the jet, so halving 1.5 m to 0.75 m takes it from 5.42 to 3.84 m/s. The tool gives speed only, not liters per minute. Is it a draining tank or a siphon you are working on?

Comments

  • Be the first to comment.

Popular calculators

All Calculators