Radius of Curvature Calculator

Enter the curvature κ in 1/m.

Result

50.0000 m
0.0200 1/m
R = 1/κ

How it is calculated

The radius of curvature is the reciprocal of the curvature: R = 1 ÷ κ, where κ (kappa) is in reciprocal meters (1/m) and R comes out in meters. A curvature of 0.02 1/m therefore means a circle of radius 50 m fits the curve at that point. The result is printed with four decimals, followed by your curvature echoed back.

A curvature of exactly 0 is a straight line, whose radius is infinite, so the tool gives no result for it. Curvature is a magnitude, κ = ‖dT/ds‖ ≥ 0, as OpenStax defines it, so a negative entry (a signed curvature, which only says which way a plane curve turns) is read as its size: the tool gives R = 1/|κ|, shows |κ| and says that the sign was dropped. The curvature echo is rounded to four decimals too, and a very small κ keeps its significant digits: 0.00001 is displayed as 0.00001, with R = 100,000 m.

Worked example

A road bend has a measured curvature of κ = 0.02 per meter. R = 1 ÷ 0.02 = 50.0000 m. This means that at that point the road follows a circle of radius 50 m. If a designer wants a gentler bend with a radius of 200 m, the curvature must drop to 1 ÷ 200 = 0.005 1/m, a quarter of the original. Doubling the curvature, to 0.04, would halve the radius to 25 m.

Try this example →

Common mistakes

  • Entering the radius in the curvature field. The input is κ in 1/m, not the radius; typing 50 gives R = 0.02 m, the opposite of what was meant.
  • Using other units for κ, such as 1/km, 1/cm or degrees per 100 ft. The result is labeled in meters, so convert the curvature to 1/m first.
  • Entering 0 for a straight section and expecting an answer. A straight line has infinite radius, so the tool returns nothing.
  • Expecting a negative radius for a negative curvature. The radius is a length, 1/|κ|; the sign of a signed curvature only tells which way the curve turns.
  • Reading the curvature echo as rounded away for very small values. It keeps its significant digits: 0.00001 shows as 0.00001, and the radius is 100,000 m.

Sources

About this calculator

Curvature (κ) measures how sharply a curve bends at a point — a tight turn has high curvature, a nearly straight path has curvature close to zero. The radius of curvature is simply its reciprocal, R = 1/κ: it's the radius of the circle that best hugs the curve at that exact point, so a small radius means a sharp bend and a large radius means a gentle one.

This relationship is used across physics and engineering — optical engineers use it to describe lens and mirror surfaces, structural and highway engineers use it to design safe road and rail curves, and mechanical engineers use it in beam-bending and cam-profile calculations.

Was this helpful?

You can pick up to 3 reactions.

Comments

  • Be the first to comment.

Popular calculators

All Calculators