Poisson's Ratio Calculator

Find the ratio of transverse contraction to longitudinal extension in a stretched or compressed material.

Result

0.30

How it is calculated

The tool computes ν = −εlateral ÷ εaxial, minus the ratio of the strain across the load to the strain along it; the minus sign accounts for the change of sign between the two strains (Roylance, MIT). Strain is the change in length divided by the original length, a plain number with no unit. Enter both strains in the same form, for example both as fractions or both as percent, and the units cancel. The result has two decimals. Axial strain of zero gives no result. The sign is kept. In a normal tension test the lateral strain is negative while the axial strain is positive, so ν is positive; strains of the same sign give a negative ν, which the tool flags: either the material widens when stretched (an auxetic material) or a sign was typed wrong. The tool does not limit the result, so it will show values the usual 0 to 0.5 range for ordinary solid materials would not allow.

Worked example

A bar is pulled so that its length grows by a strain of 0.0028, and its width shrinks by a strain of −0.00084. Poisson's ratio is minus lateral over axial: −(−0.00084 ÷ 0.0028) = −(−0.30). The tool shows 0.30, in the range typical of many metals. Entering +0.00084 for the lateral strain would give −0.30, and the tool would say that a negative ratio means a material that widens when stretched, or a sign typed wrong.

Try this example →

Common mistakes

  • Mixing forms of strain, such as the lateral strain in microstrain (840) and the axial strain as a fraction (0.0028). The ratio is then off by a factor of a million.
  • Entering a change in length instead of a strain. A 0.3 mm change is not a strain until it is divided by the original length.
  • Entering the lateral strain of a tension test as a positive number. The width shrinks, so the strain is negative; typed as positive it gives a negative ν, which the tool flags.
  • Putting the axial strain in the lateral field. The ratio is lateral over axial, and the swap returns the inverse, 3.33 instead of 0.30.
  • Ignoring results above 0.5. Nothing is checked, so −0.01 over 0.005 returns 2.00. For an ordinary solid that signals a measurement or entry error.

Sources

About this calculator

Poisson's ratio (ν, nu), named after French mathematician Siméon Poisson, quantifies how much a material contracts in directions perpendicular to an applied load: it is defined as the negative ratio of transverse (lateral) strain to axial (longitudinal) strain during uniaxial tension or compression. Most engineering metals have a Poisson's ratio near 0.3, incompressible materials like rubber approach the theoretical upper limit of 0.5, and cork is famously close to 0, which is why it can be pushed into a bottle without bulging sideways.

Mechanical, civil, and materials engineers use Poisson's ratio alongside Young's modulus and shear modulus to fully characterize a material's elastic behavior in stress analysis, finite element modeling, and structural design — it directly affects calculations like stress concentration around holes, buckling behavior, and how pressurized pipes or vessels deform.

This calculator takes your measured lateral and axial strain from a tensile or compressive test and computes the resulting Poisson's ratio as minus lateral ÷ axial strain, keeping the sign: a negative ratio, as in auxetic materials, is shown as negative and explained. The result is not checked against the usual 0 to 0.5 range, so judge it against your material yourself.

Was this helpful?

You can pick up to 3 reactions.

Comments

  • Be the first to comment.

Popular calculators

All Calculators