Mil to Micrometer Converter

Enter a thickness in mils to convert to micrometers.

Result

88.90 µm
0.0889 mm

How it is calculated

The conversion multiplies by exact factors: µm = mil × 25.4 and mm = mil × 0.0254. One mil is 0.001 inch and one inch is defined as 25.4 mm, so one mil is exactly 25.4 micrometers. Micrometers are shown with two decimals and millimeters with four, and a value that would round to zero keeps its significant digits: 0.001 mil shows as 0.03 µm and 0.0000254 mm. Thousands separators appear in large results. A negative number gives no result, since a thickness cannot be below zero. Do not confuse the mil (thousandth of an inch) with the millimeter, which is about 39.37 times larger.

Worked example

A protective coating is specified at 3.5 mil dry film thickness. Micrometers: 3.5 × 25.4 = 88.90 µm. Millimeters: 3.5 × 0.0254 = 0.0889 mm, which the tool shows as 0.0889 mm. So a data sheet that asks for 90 µm is just about met by a 3.5 mil coating, while a 3 mil coating (76.20 µm) would fall short of it.

Try this example →

Common mistakes

  • Reading mil as millimeter. A mil is a thousandth of an inch, about 0.0254 mm, so 5 mil is roughly 127 µm, not 5 mm.
  • Treating mil as a thousandth of a millimeter. That unit is the micrometer, and one mil is 25.4 of them.
  • Using the wrong unit for the output. The first result is in µm and the second in mm; an 88.90 µm film is 0.0889 mm, not 0.889 mm.
  • Entering a thickness in inches. 0.0035 inch must be typed as 3.5 mil here, otherwise the answer is a thousand times too small.

Sources

About this calculator

A mil (also called a “thou,” short for thousandth) is one thousandth of an inch, a unit used almost exclusively in manufacturing and engineering contexts where inch-based measurements are the norm — coating and film thickness, wire gauges, sheet metal, and machining tolerances.

This calculator converts a thickness in mils to micrometers (1 mil = 25.4 µm exactly) and to millimeters, letting engineers and quality control teams translate between the imperial mil and the metric micrometer that most international specifications, datasheets and measuring equipment use — a simple but essential conversion wherever a US-sourced spec meets a metric production line.

Was this helpful?

You can pick up to 3 reactions.

Note from the editors

Tolerances convert as easily as thicknesses. A coating called out at 0.5 mil is 12.70 µm, which the tool also gives as 0.0127 mm, and a plus or minus 0.5 mil tolerance is therefore plus or minus 12.70 µm. For very thin films read the micrometer line, because the millimeter line stops at four decimals. Do you work from drawings in mils or from metric data sheets?

Comments

  • Be the first to comment.

Popular calculators

All Calculators