Mash Efficiency Calculator

See how much of your grain's sugar you extracted.

How it is calculated

Efficiency compares the sugar actually in the wort with the most the grain could give. actual points = (OG − 1) × 1000 × volume and maximum points = grain weight × PPG, then efficiency % = actual / maximum × 100. OG is the measured specific gravity of the wort (written as 1.050). Volume is in US gallons and grain weight in pounds, or in liters and kilograms with the unit system set to metric; PPG is the grain's potential in points per pound per gallon in both systems, the figure malt sheets give. In metric the tool turns liters into gallons (÷ 3.785) and kilograms into pounds (÷ 0.4536) first, which is the same as efficiency % = (OG − 1) × 1000 × liters ÷ (kg × PPG × 8.3454) × 100, so the same mash gives the same efficiency in either system. OG must be above 1 and the other three values above zero. Because a mash cannot give more than the grain holds, any input set that works out above 100% (usually a unit or typing slip) shows no result instead of an impossible figure. Use a weighted average PPG if you mix grains.

Worked example

You collect 5.5 gal of wort at OG 1.050 from 11 lb of grain with an average potential of 37 PPG. Actual points = (1.050 − 1) × 1000 × 5.5 = 275. Maximum points = 11 × 37 = 407. Efficiency = 275 / 407 × 100 = 67.57%. Result: mash efficiency 67.57%.

Try this example →

Common mistakes

  • Entering the gravity as 50 or 1050 instead of 1.050. The field expects the specific-gravity form; 50 would imply far more than 100% and shows no result.
  • Typing liters and kilograms while the unit system is on US units. The fields then read gallons and pounds: a 21 L batch typed as 21 with 11 lb of grain gives over 100% and no result. Switch the unit system to metric, or enter about 5.5 gal.
  • Converting the PPG to points per kilogram per liter when the unit system is on metric. The field takes PPG in both systems; 308.8 instead of 37 gives an efficiency about one eighth of the real one.
  • Using the volume at the end of the boil or in the fermenter instead of the wort volume matching the gravity reading. Gravity and volume must be from the same point.
  • Reading gravity from a hot sample without temperature correction. A hot wort reads too low and understates your efficiency.
  • Entering one grain's PPG when the bill has several, such as a high-potential base malt plus low-potential specialty malt. Use a weighted average or the figure will be off.

About this calculator

Mash efficiency measures how much of the sugar theoretically available in your grain bill actually made it into the wort, calculated by comparing your measured original gravity and batch volume against the grain's potential extract (expressed in points per pound per gallon) — a core recipe metric that determines a beer's final strength and ABV.

All-grain homebrewers use it to fine-tune their process — crush consistency, mash temperature, sparge technique — because a consistent, known efficiency is what lets a brewer hit a target original gravity reliably and scale recipes up or down with confidence.

Was this helpful?

You can pick up to 3 reactions.

Comments

  • Be the first to comment.

Popular calculators

All Calculators