Clover Lawn Seed Calculator

Enter your lawn size to find how much clover seed to buy.

How it is calculated

Seed is sold and sown by weight per 1,000 square feet, so the calculation is seed lb = area ÷ 1000 × rate and seed oz = seed lb × 16. area is the lawn size in square feet and rate is the seeding rate in pounds per 1,000 sq ft, which you take from the seed packet for the clover you are using. Choosing Metric under Units switches the inputs and outputs to metric: area in m², rate in grams per m² (1 lb per 1,000 sq ft = 4.88 g/m²), seed in kg and g. If the rate field is left empty, the tool falls back to 0.25 lb per 1,000 sq ft (1.22 g/m²). Area and rate must both be above zero. Results are shown to two decimals in pounds and ounces (kilograms and grams in metric). The calculation counts only the area you enter, so measure the actual seeded area, not the whole yard, and remember it gives the amount of seed, not the number of bags.

Worked example

A lawn of 3,200 sq ft is overseeded at 0.5 lb per 1,000 sq ft. Step 1: the area in thousands is 3,200 ÷ 1,000 = 3.2. Step 2: seed needed = 3.2 × 0.5 = 1.60 lb. Step 3: in ounces, 1.60 × 16 = 25.60 oz. The tool also repeats the area as 3,200 sq ft. With the default rate of 0.25 the same lawn would need half as much, 0.80 lb, so the rate you choose matters more than the area.

Try this example →

Common mistakes

  • Entering the area in square meters with Units set to US. Choose Metric to enter m², or multiply square meters by 10.764 first.
  • Entering a rate per acre, or mixing units. In US units the rate is pounds per 1,000 square feet, as US seed labels state it; in metric it is grams per m².
  • Leaving the default 0.25 for every type. The rate depends on the clover, on whether you are overseeding an existing lawn or sowing it alone, and on the label, so use the packet's figure.
  • Including house, beds and paths in the area. Use only the lawn that will be seeded.
  • Ignoring seed quality and coating. Coated seed weighs more per seed, so follow the coated-seed rate on the label rather than reusing an uncoated one.

Sources

Based on a common rule of thumb; no published standard was found.

About this calculator

Clover seed is sown by weight per unit area, but the right rate differs by type: micro clover, bred to stay short and blend into an existing lawn, is typically overseeded at a much lower rate than white clover grown as a standalone low-maintenance, nitrogen-fixing groundcover. This calculator multiplies your lawn's area by the chosen seeding rate to estimate the pounds (or, in metric, kilograms) of seed needed to cover it.

Clover lawns have grown popular with homeowners seeking a drought-tolerant, pollinator-friendly, low-mow alternative to a pure grass lawn, since clover fixes its own nitrogen from the air and needs less fertilizer and irrigation — getting the seeding rate right avoids both patchy, thin coverage from under-seeding and wasted seed from over-seeding.

Was this helpful?

You can pick up to 3 reactions.

Note from the editors

In US units the area is square feet, so convert square meters first. A small patch shows the scale: 800 sq ft at the default rate is only 0.20 lb, or 3.20 oz, so weigh it on a kitchen scale. The result is seed alone: any sand you mix in for even spreading is extra. What are you sowing into?

Comments

  • Be the first to comment.

Popular calculators

All Calculators