Thermostat Setback Savings Calculator

Enter your annual heating cost, setback degrees and setback hours to see the savings.

Result

$75.00
$1,425.00
5.0%
DOE's 1% per °F is for an eight-hour setback and it gives no figure for other durations, so this is the eight-hour estimate.

How it is calculated

The tool follows the U.S. Department of Energy's consumer guide: “You can save 1% on heating bills for each 1°F you set it back during an eight-hour period.” So saving % = setback °F, the saving in money is annual cost × saving % ÷ 100, and the new cost is the annual cost minus that saving. DOE gives no figure for other durations. From 8 to 24 hours the tool shows the eight-hour figure (a longer setback saves at least that), and when the hours are not 8 the result says so. Fewer than 8 hours gives no result: crediting a short setback with the full eight-hour saving would overstate it, by about four times for 2 hours. The setback must be above 0 and at most 20 °F, and the hours at least 8 and at most 24; values outside those ranges return no result. With the unit system set to metric the setback is entered in °C: a temperature difference converts × 1.8 with no 32 offset, so the rule becomes 1.8% per °C (saving % = setback °C × 1.8), and the 20 °F limit is about 11.1 °C. The same setback gives the same saving in both systems. DOE also says a setback when you are away and asleep can save as much as 10%. Climate, insulation and how the heating recovers change the real figure.

Worked example

Annual heating cost of 1,500, thermostat lowered by 5 °F. DOE's figure is 1% per °F for an eight-hour setback, so the saving is 5%: 1,500 × 5 ÷ 100 = $75.00, and the new annual cost is 1,500 − 75 = $1,425.00. If you enter 10 hours instead of 8, the tool still shows the eight-hour figure and says so, because DOE gives no figure for longer setbacks. A setback shorter than 8 hours, such as 2 hours, gives no result, because DOE gives no figure for it either.

Try this example →

Common mistakes

  • Entering the setback in °C while the unit system is on US units. The field then reads °F, so a 3 °C drop typed as 3 claims 3% instead of 5.4%; switch the unit system to metric instead.
  • Entering the new temperature (for example 64) instead of the number of degrees lowered. The tool rejects anything above 20 °F, but a value like 15 would claim a 15% saving.
  • Using the monthly or winter-only bill as the annual cost. The result is a percentage of whatever you type, so use the full year's heating cost.
  • Expecting a longer setback to save proportionally more, or a short one to save a share. DOE's figure is for eight hours: the tool does not scale it by hours, and it gives no result for a setback under 8 hours.
  • Expecting a bigger saving by adding more degrees. Deep setbacks lose some of the saving to the recovery period; DOE puts the typical saving at up to 10%.

Sources

About this calculator

The calculator is built on the well-known heating rule of thumb popularized by U.S. Department of Energy field studies: for roughly every degree Fahrenheit you set the thermostat back, you save about 1% of your heating cost per 8 hours of daily setback (1.8% per degree Celsius, since 1 °C is 1.8 °F) — a rule this calculator applies to the annual heating cost you enter for an eight-hour setback, the period DOE's figure is given for (it does not scale the saving for other durations). The relationship is close to linear over the modest setbacks most households actually use — a few degrees overnight or while the house is empty during the workday — because heat loss through walls, windows, and roof scales with the difference between indoor and outdoor temperature, so a lower indoor target means slower, cheaper heat loss.

Programmable and smart thermostats made this kind of scheduled setback routine, and homeowners use a savings estimate like this one to decide whether a nightly or daytime setback is worth the temporary chill, and to set realistic expectations before buying a smart thermostat marketed on energy savings. The actual percentage saved varies with climate, insulation quality, and how efficiently the furnace responds to recovery, but the 1%-per-degree-per-8-hours figure remains the standard back-of-envelope estimate used by energy advisors.

Was this helpful?

You can pick up to 3 reactions.

Comments

  • Be the first to comment.

Popular calculators

All Calculators