Rule of Mixtures Modulus Calculator

Enter the fiber volume fraction and the fiber and matrix moduli.

Result

139.40 GPa
8.55 GPa
60.00%

How it is calculated

Two formulas are evaluated from the fiber volume fraction Vf (0 to 1, as a fraction), the fiber modulus Ef and the matrix modulus Em. The Voigt value is E = Vf × Ef + (1 − Vf) × Em, a volume-weighted average that applies when load is carried along the fibers. The Reuss value is E = 1 / (Vf / Ef + (1 − Vf) / Em), which applies when load crosses the fibers. The results are labeled GPa, so enter both moduli in GPa. Vf may be 0 or 1, but moduli must be above zero. The real composite lies between the two numbers, and the tool does not say where. It also echoes Vf as a percentage.

Worked example

Take Vf = 0.6, a fiber modulus of 230 GPa and a matrix modulus of 3.5 GPa. Voigt: 0.6 × 230 + 0.4 × 3.5 = 138 + 1.4 = 139.40 GPa. Reuss: 0.6 / 230 = 0.002609 and 0.4 / 3.5 = 0.114286, which add up to 0.116894, and 1 / 0.116894 = 8.55 GPa. Along the fibers the composite is therefore stiff, close to 139 GPa, while across them it can be no stiffer than about 8.55 GPa. The gap between the bounds is large because the fiber is about 66 times stiffer than the matrix.

Try this example →

Common mistakes

  • Typing the fiber fraction as 60 instead of 0.6. A value above 1 returns no result.
  • Entering moduli in MPa or psi while the answer is labeled GPa. Convert to GPa first, for example 230 GPa and not 230000.
  • Mixing up weight fraction and volume fraction. Vf is a volume fraction, so a composite that is 60% fiber by weight has a lower Vf because fiber is usually denser than resin.
  • Using the Voigt number for a load applied across the fibers. That direction is closer to the Reuss value, which is far lower when the two moduli are very different.
  • Reading either number as a measured stiffness. They are bounds, and voids, fiber misalignment and short fibers push the real modulus below the Voigt value.

Sources

About this calculator

For a fiber-reinforced composite, the rule of mixtures gives two bounding estimates of the elastic modulus. The Voigt (parallel, isostrain) upper bound, E_V = Vf·Ef + Vm·Em, applies when loading runs along the fiber direction; the Reuss (series, isostress) lower bound, 1/E_R = Vf/Ef + Vm/Em, applies when loading runs transverse to the fibers.

A real composite's stiffness falls somewhere between these two bounds depending on the loading direction and fiber arrangement. This calculator is used by materials engineers and composite mechanics students to get a quick stiffness estimate before turning to more detailed micromechanics models or finite-element analysis.

Was this helpful?

You can pick up to 3 reactions.

Comments

  • Be the first to comment.

Popular calculators

All Calculators