Downhill Energy-Equivalent Pace Calculator

See the pace that takes the same metabolic power on a downhill or uphill grade as your flat pace, from Minetti's energy-cost curve.

Result

215 s/km
59.77%

How it is calculated

The tool uses the Minetti et al. (2002) polynomial for the energy cost of running per meter at gradient i (rise over run, so −10% is i = −0.10):

C(i) = 155.4·i⁵ − 30.4·i⁴ − 43.3·i³ + 46.3·i² + 19.5·i + 3.6

ratio = C(i) / C(0), and adjusted pace = flat pace × ratio

Pace is entered in seconds per kilometer (6:00/km = 360), gradient in percent, negative for downhill. The flat cost C(0) is 3.6, so the ratio is the cost relative to flat running and the same ratio scales your pace, which assumes equal effort. The adjusted pace is rounded to whole seconds. Gradients beyond ±45% return no result. A positive gradient is also accepted and gives a slower pace.

The scaling rests on what Minetti et al. measured: 3.4 J/kg/m on the level (the fitted curve gives 3.6), a lowest cost of 1.73 at −20%, and a cost per meter that does not change with speed, so at equal metabolic power speed falls as the cost rises. They also note that speeds predicted this way on descents are well above those run in downhill races, so the result is the energy-equivalent pace, not a realistic race split.

Worked example

A runner holds 6:00 per km on flat ground, so the flat pace is 360 s/km, and the descent is −10%.

i = −0.10. C(−0.10) = −0.0016 − 0.0030 + 0.0433 + 0.4630 − 1.9500 + 3.6 ≈ 2.152. Ratio = 2.152 / 3.6 = 0.5977, shown as 59.77%.

Adjusted pace = 360 × 0.5977 ≈ 215, so the tool returns 215 s/km, about 3:35 per km, for the same effort as 6:00 on the flat.

Try this example →

Common mistakes

  • Typing the pace as minutes (6) or as 6.00 instead of 360 seconds. The field is seconds per km, so 6 gives a meaningless 4 s/km.
  • Entering the gradient as a positive number for a descent. Downhill must be negative; a positive value is treated as uphill and makes the pace slower.
  • Confusing gradient percent with degrees. A 10% grade is about 5.7 degrees, not 10.
  • Expecting faster and faster pace on ever steeper slopes. Past roughly −20% the cost curve turns back up, and at −45% the result is slower than flat.
  • Reading the adjusted pace as a race split. It is the pace of equal metabolic power; Minetti et al. note that such predictions on descents are well above what runners reach in downhill races, and braking, footing and fatigue on technical descents slow you further.

Sources

About this calculator

Running downhill lets gravity do part of the work, so the same metabolic effort produces a faster pace than on flat ground, up to a point. This page uses the energy model of Minetti et al. (2002), who measured the energy cost of running on a treadmill from −45% to +45%: 3.4 J/kg per meter on the level (the fitted curve the tool uses gives 3.6), independent of speed, falling to a low of 1.73 at −20% and rising again to 3.92 at −45% as eccentric braking on the quads takes over. Because the cost per meter does not depend on speed, the same metabolic power gives a pace that scales with the cost ratio, so at −10% the model's pace is about 60% of the flat pace. Minetti et al. point out that speeds predicted this way on descents are well above those reached in downhill races: footing, braking and muscle soreness keep real runners slower, so read the result as the energy-equivalent pace, not a split you can expect to hold.

Trail and mountain runners use downhill pace adjustments to plan realistic segment splits on courses with significant descent, to avoid overcooking the legs on early downhills at the cost of later climbs, and to compare effort — not just raw pace — across route sections. Coaches also use grade-adjusted pace to make apples-to-apples comparisons between training runs done on different terrain profiles.

Was this helpful?

You can pick up to 3 reactions.

Comments

  • Be the first to comment.

Popular calculators

All Calculators